When sketching, I have most of snap features turned on (midpoint, end point, quadrant etc). however after i finish sketching (but still in sketch mode) the sketch can be moved, it doesn't seem to fix constain automatically. is this the case with NX6? you have to constrain everything manually?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Snap To
- Thread starter Finglas
- Start date
There are 'inferred' constraints that will be applied automatically. This is an option that can be enabled/disabled and there are options to control which constraints you want applied automatically. Check out the sketch preferences and the customer defaults for sketching for these options.
- Status
Similar threads
- Locked
- Question