Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Sol 400 RBE3 with quadratic elemnts (ex. TET10).

Status
Not open for further replies.
marulanda

marulanda

New member
Oct 16, 2016
24
Someone told me that to use a middle nodes (for quadratic element ex. TET10) as master in an RBE3 is non recommendable, especially in a sol 400 non-linear-static analysis, the solution might not converge.
Is it true and why???
Thanks

Best regards.
 
Status
Not open for further replies.

Similar threads

jmarkus
  • Locked
  • Question
NX SimCenter 3D Nastran SOL 106 - Creating 'aligned' GAP elements
Replies
7
Views
714
SWComposites
SWComposites
jmarkus
  • Locked
  • Question
Nastran SOL 106 - Bi-/Tri-Linear Stress Strain result from Non-linear Material curve 1
Replies
8
Views
1K
tim1958
tim1958
catalina29
  • Locked
  • Question
Nastran SOL400 normal modes analysis with touching contact
Replies
1
Views
2K
karachun
karachun
jmarkus
  • Locked
  • Question
NASTRAN SOL 106 in SimCenter 3D - Shell Thickness Output? 1
Replies
7
Views
486
sdm919
sdm919
Gabrieldondeu
  • Locked
  • Question
Freq response (SOL 111) of a composite model on Nastran: no stress calculated in pcomp elements
Replies
1
Views
407
dmapguru
dmapguru

Part and Inventory Search

Sponsor

Back
Top Bottom