fisken90
Mechanical
- Feb 11, 2016
- 6
Hi Guys!
I'm trying to bend a pipe in Abaqus. I following this video: on my model in the picture attached. I'm using the block on top to bend the pipe underneath. The job runs and completes but nothing happens and I have the following error messages:
MPCS (EXTERNAL or INTERNAL, including those generated from rigid body definitions), KINEMATIC COUPLINGS, AND/OR EQUATIONS WILL ACTIVATE ADDITIONAL DEGREES OF FREEDOM
Output request rm1 is not valid since it requests output at a dof that is not active
Output request rm2 is not valid since it requests output at a dof that is not active
Output request rm3 is not valid since it requests output at a dof that is not active
Output request ur1 is not valid since it requests output at a dof that is not active
Output request ur2 is not valid since it requests output at a dof that is not active
Output request ur3 is not valid since it requests output at a dof that is not active
Boundary conditions are specified on inactive dof of 3 nodes. The nodes have been identified in node set WarnNodeBCInactiveDof.
There are 2 unconnected regions in the model.
Any tips or do I need to provide more information?
Thanks in advance!
I'm trying to bend a pipe in Abaqus. I following this video: on my model in the picture attached. I'm using the block on top to bend the pipe underneath. The job runs and completes but nothing happens and I have the following error messages:
MPCS (EXTERNAL or INTERNAL, including those generated from rigid body definitions), KINEMATIC COUPLINGS, AND/OR EQUATIONS WILL ACTIVATE ADDITIONAL DEGREES OF FREEDOM
Output request rm1 is not valid since it requests output at a dof that is not active
Output request rm2 is not valid since it requests output at a dof that is not active
Output request rm3 is not valid since it requests output at a dof that is not active
Output request ur1 is not valid since it requests output at a dof that is not active
Output request ur2 is not valid since it requests output at a dof that is not active
Output request ur3 is not valid since it requests output at a dof that is not active
Boundary conditions are specified on inactive dof of 3 nodes. The nodes have been identified in node set WarnNodeBCInactiveDof.
There are 2 unconnected regions in the model.
Any tips or do I need to provide more information?
Thanks in advance!