solid by face in v5

[pc12]

dear all, thanks in advance.
i have faces in v4 and now i want to create a solid in v5 using it.
how to do? is it possible?

best regards
fabio

 

[Kapmc]

pc12:

If the surfaces that you brought over from V4 create a closed volume, you can use the close surface function in part design.

If the surface do not you can then use these surfaces as splitters.

 

[solid7]

A) Are you trying to extrude a face, or close a volume?
B) If the surfaces do not close, there is almost a 100% chance that you cannot use them to split (without extending them) A gap would also represent a face that does not completely intersect the part that it is cutting

Please clarify your situation.

-----------------------------------------------------------
Catia Design|Catia Design News|Catia V5 blog

 

[pc12]

sorry, if the question was not clear.
i have closed faces and i want to create a solid.
i mean, in v4 you could do in this way:
create a volume with closed faces then a solid by solid/complex/volume.
how to do in v5?
best regards
fabio.

 

[DBezaire]

pc12 - refer back to Kapmc -
Part Design work bench
Insert Body
Closed Surface - surface based features toolbar
select closed surface.

Regards,
Derek