Solid Fill Problem on a Logo

[diamondcat]

Hi,

I drew up our company logo and used the Area Hatch/Fill command to fill in some of the areas. When I make the logo into a block, half of the solid area goes away. Also, when I make a window around the logo and the solid to select for a move, the lines will move but only portions of the solid fill will move. I would appreciate any help I can get.

Thanks,
Lori

 

[ctopher]

also sounds like a display problem. What hardware/memory/etc are you running?

 

[diamondcat]

I am running the following:

XP Pro
Dell Precision 450
Xeon 2.8 G Processor
NVIDIA Quadro FX 1000 Video

 

[ctopher]

RAM? Should have minimum 1 GB, 2 GB preferred. I had not much luck with a pc while back with Xeon, I use Intel P4,minimum 3.4 processor from now on.

 

[diamondcat]

I have 2G of RAM.

 

[MadMango]

I would convert your logo into a BMP or other graphic file format for use in the title block. SW has to spend time to draw all those little hatch segments.

[blue]"But what... is it good for?"[/blue]
Engineer at the Advanced Computing Systems Division of IBM, 1968, commenting on the microchip.
Have you read faq731-376 to make the best use of Eng-Tips Forums?

 

[diamondcat]

Okay, I'l try that thanks.