Solid Problem

[atcoast]

In v4.2 drafting mode i am updating a large view and I get an error "solid problem" what causes this? how can you find the problem solid in a large overlay? Thanks Atcoast

 

[itsmyjob]

Hi,

After the error message type /help it ay give you more info about where the problem is.

I said 'may', didn't I

Eric N.
indocti discant et ament meminisse periti ​

 

[solid7]

No, you said "it ay," but that's probably just as good...




**************
Check out CATBlog!

 

[ferdo]

Hi,

Are you sure that your CATIA settings for usrenv.dcls are OK for what are you doing?

If I remember well, I had a similar problem in the past. The problem was that my settings for CATIA were to "small".

There is a very good article on IBM site called "MEMORY MANAGEMENT IN AUXVIEW2, METHODOLOGY"

May be this article can help you.

Regards
Fernando

 

[Darrude]

is your Model clean. Try typing in /cln to check for errors. Caterogry 1 and 2 errors will stop drawings from updating in Auxview 2.

Regards,

Darren

 

[atcoast]

Thanks everyone the problem is solved. Seems there were a few solids that needed to be updated in detail wsp.

Thanks again.