SOLIDEDGE 2020

[GPowers2]

People,

I have a great 3D Model , well done SolidEdge Team it was dead easy and a pleasure to use
hooked the 3D Model to my Drafting sheet - no Problem.
issue i have now ( and it should be easy if someone can point me in the right direction ) is i need to change from the default 1st Angle projection to 3RD angle for placement of the Elevations and section. ? where is that setting to adjust

many thanks

gary

 

[GPowers2]

folks,

I have the answer from another forum, stand easy, I am sure i will
have further questions as time goes by.

cheers .... gary