Solidworks 2001 plus question

[vikdayal]

Hello everyone !

Has someone heard of a problem with Solidworks 2001 plus and a helical groove made by cut sweep, the groove actually ends beyond the end of helix by a few degrees. Now when done in Solidworks 2004, this problem is not there?

Please do let me know if you have heard of such a problem.

Regards

Vik

 

[FrenchCAD]

From memory, I would say yes, I had this kind of problem a few times with SW2001+

I'll let other people tell you more about it, since I haven't used SW2001+ for a few years now.

Cyril Guichard
Mechanical Engineer

 

[vikdayal]

Thank you very much Cyril !