Solidworks 2010 Design Tree

[Duke400ex]

I have one specific part that every time it is opened for some reason there are two design trees. One is in the normal position but the other is under it. I didn't pay much attention to it until I was trying to put a relative view in the drawing and the second is stopping it from letting me choose what I want to view. Any Ideas?

 

[ctopher]

Grab the horiz line that splits them and drag it down to the bottom.

Chris
SolidWorks 10 SP4.0
ctopher's home
SolidWorks Legion

 

[CorBlimeyLimey]

http://help.solidworks.com/2010/Eng...egacyhelp/sldworks/ui/split_panel_display.htm

 

[Gupta65]

Can you post a quick snap shot of what that looks like as any of the above option can be a solution but depends on what you have over there.

Deepak Gupta
SW 2009 SP4.1 & 2007 SP5.0
MathCAD 14.0
Boxer's Blog