Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

SolidWorks 2011 Flow Simulation HELP

Thread starter nikdomkin
Start date Nov 9, 2012

Status: Not open for further replies.

Nov 9, 2012

nikdomkin

Mechanical

Hello Everyone,
I am new to this software and would like to know if its possible to simulate rotational air flow to an object within its computational domain but refrence point would be out side of the computatuional domain. your thoughts would be appreciated.