SolidWorks Error "Please enter an integer between 2 and 256"

[mikes422]

thread559-241988

The previous thread on this error was closed, but I wanted to post the solution for anyone else who might need it.

Error Message: When attempting to change measurement units (Measure > Units/Precision), this message appears: "Please enter an integer between 2 and 256".

Solution: Go to Options > Document Properties > Units. Make sure that any active fields in the Fractions column are filled in with an integer between 2 and 256. Press OK and the error should be gone.

 

[Gupta65]

Another method to fix the same: Measure Error – 2 and 256

Deepak Gupta
SW 2009 SP4.1 & 2007 SP5.0
MathCAD 14.0
Boxer's Blog