Solidworks hole callout symbols for CSK, CBORE, DEPTH etc

[rattler]

Hi
I work in the UK and produce drgs to BS8888. I'm looking into whether we can use the SolidWorks hole tables without further modification. I don't think the symbols SolidWorks uses for CSK, CBORE, DEPTH etc are used in the BS spec? Does anyone in the UK use these symbols and if so how do they relate to the BS spec?
Thanks

 

[Eltron]

You might try asking this question over in the Drafting Standards forum.

Dan

http://www.eltronresearch.com

Dan's Blog