SolidWorks Sheet Metal - Need Help 1

[digitalflowdesign]

Hi,

I have a project requiring a SolidWorks 2013 sheet metal part. The main piece created using a Base Flange. The two end pieces is the problem. The main piece on both ends needs capped off while maintaining the upper most 1" top flange. I have the end piece started but it needs to be trimmed to match the main pieces profile (see the attached grab from AutoCAD). Ultimately I need the flat pattern of this piece. Any suggestions would be appreciated. Please see attached screen grabs and SW file.

Thanks!

 

[CorBlimeyLimey]

Are you looking for a one piece or three piece solution?

 

[digitalflowdesign]

One piece if possible.

 

[CorBlimeyLimey]

I don't have SW13 installed, so you will have to figure out the steps from the feature tree.
Realise though that the underlying sketch of a bend flange can be edited to suit the shape of the required flange.

http://help.solidworks.com/2014/english/SolidWorks/sldworks/c_Profile_Sketches.htm#acu1322749622115

The extended faces at the corners can be cut away with regular SW functions.

 

[CorBlimeyLimey]

The flat may help explain.

 

[digitalflowdesign]

Thank you so much!!
I was in over my head with this one and appreciate your sacrifice of time and efforts spent on helping a complete stranger. I will give it another try!
Considering the times we are living in, it restores my faith in human kind.
All the best to you!!!