Solidworks2004 printing

[6878]

We have a HP650 plotter and when I try to plot from Solidwords2004, it keeps spitting out blank paper. Your help is greatly appreciated.

Mike

 

[SBaugh]

Have you upgraded to SP1 yet? I would do that, plus make sure you have the latest drivers.

Regards,

Scott Baugh, CSWP

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376

 

[Roller1]

Do you see anything if you do a Print Preview?

 

[CMcF]

We have SW2004 and Windows XP, we had to make the following change;
Set SW to print "scale to fit", then under the printer options, "advanced" change the printer scaling from "Auto" to "fixed (100%)".
This problem was not highlighted by the print preview.

Swing low sweet chariot!