coffeeprince
Mechanical
- Nov 6, 2009
- 1
Hi,
I just started to use Ansys and wanted to solve a plate problem for my project. My plate is a thin steel plate welded on all 4 sides. Load is uniform load on only 1 quadrant of the plate only. My model in Ansys uses Solid 92 and BC uses fixed all 4 faces of the plate. All my Vonmisese results are good, but as I refine my mesh, my SMX in the middle of one edge keeps growing and does not converge or plateau out. I tried refining it many times, but that SMX just keeps increasing.
Does that mean my plate cannot support this weight I am putting onto the plate or have I set up my model wrongly (Is it realistic to model weld as FIX BC in ansys)?
Many thanks for any advice. Cheers.
I just started to use Ansys and wanted to solve a plate problem for my project. My plate is a thin steel plate welded on all 4 sides. Load is uniform load on only 1 quadrant of the plate only. My model in Ansys uses Solid 92 and BC uses fixed all 4 faces of the plate. All my Vonmisese results are good, but as I refine my mesh, my SMX in the middle of one edge keeps growing and does not converge or plateau out. I tried refining it many times, but that SMX just keeps increasing.
Does that mean my plate cannot support this weight I am putting onto the plate or have I set up my model wrongly (Is it realistic to model weld as FIX BC in ansys)?
Many thanks for any advice. Cheers.