Spherically Adjustable Support with Threaded ID

[wahoo88]

I'm looking for an assembly that looks and functions just like a plane spherical bearing, but has a threaded inside diameter (5/8-18 UNF). This will be used in an adjustable attach fitting for a one-off lifting fixture, so I only need 12 of these. Anyone know of any suppliers who make something like this?
Thanks,
Andy

 

[BUGGAR]

I can't picture it. I'm thinking of that welding fixture consisting of a bowling ball between two disk brake rotor clamps. The ball is drilled for a threaded shaft which holds a vise and moves spherically with the ball.

 

[BUGGAR]

Or maybe an automotive lower ball joint. Put a coupling sleeve on the stud to change sex.

 

[Tmoose]

No drawings, no pictures, no info about loading. I'm lost.

Add a threaded insert to a PSB or rod end ?

http://www.equinoxtrailers.com/img/collections/full/EyeBolt.1220582737.jpg

 

[Compositepro]

This is usually done by clamping the spherical bearing (like a rod end) between two nuts. You could just tap a normal bearing.