Spinning Model

[pulseteq]

After creating/modifying/redefining a feature the model then spins out to a defined position, I then have to zoom/spin back in to the area where the feature is to check to see if is ok.

Is there a config pro option setting to stop this or at least reduce it.

Thanks in advance

 

[PricolTech]

Hello Friend,

I too have the same problem and I'll get back the orientation by VIEW >> PREVIOUS Option.

So that I get the previous orientation before modifying.

So far I too didn't get any config option for that. If you get an option for that Please mail me.

Hope this will Help you a bit.

Cheers
Balaji Gopinath K.

 

[ProEpro]

There is a start_sketcher_3d option. If set for NO it does not align the model with the sketch plane. This might help.



ProEpro

http://www.whitelightdesign.com

 

[Alex822]

Hi guys, it sounds as if the config option "sketcher_refit_after_dim_modify" "no" may help here. Give it a try, I like it.