Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Spline Fits

Status
Not open for further replies.
korpic

korpic

Marine/Ocean
Mar 10, 2010
1
I am looking for the clearances for the fit on an N200x5x30x38-9H female spline and a W200x5x30x38-8g male spline. I have DIN 5480-1 and -10 and am trying to figure out what they say. Anyone have any tips.
 
Status
Not open for further replies.

Similar threads

APPENG
  • Locked
  • Question
Spline fits ANSI B92.1
Replies
0
Views
208
APPENG
APPENG
iucu
  • Locked
  • Question
Involute Splines
Replies
0
Views
101
iucu
iucu
thejackal3
  • Locked
  • Question
splines are not straight
Replies
2
Views
146
ornerynorsk
ornerynorsk
TorsionalStress
  • Locked
  • Question
Clearance Locational Fits On Large Diameters
Replies
2
Views
108
CoryPad
CoryPad
BlaineW
  • Locked
  • Question
Hobbing a "Grob" Spline
Replies
7
Views
242
mfgenggear
mfgenggear

Part and Inventory Search

Sponsor

Back
Top Bottom