Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Spline length control

Thread starter spoutdoors
Start date Jan 24, 2011

Status: Not open for further replies.

Jan 24, 2011

spoutdoors

Mechanical

Is there any way to constrain the length of a spline? I know I can get a static measurement but I want to force the spline to retain its length while I make changes to other geometry. I haven't been able to find a way to do it.

Or - can you think of a workaround that would let me get the spline length close to a fixed value?