Spline problem

ridenrain · Dec 12, 2003

When I draw a spline, I pick a number of different points to give the line a curve. This part is normal except the points don't show up and I can't edit the profile of the line. Anybody hear about this one?

SBaugh · Dec 12, 2003

To edit the profile you just have to drag the point. Since you don't see the point (Which is the way I like it) I just drag my cursor over the spline till it turns into a point. Once I find where all my points are I never forget where to look for them next time.

But that really doesn't answer your question. Go to Tools\Options\System Options\Sketches\(check mark)"Display Entity points in Part/Assembly Sketches.

You have to be editing the sketch for them to show up.

Regards,

Scott Baugh, CSWP [santa3]