Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Splines nodes and tables 2

Status
Not open for further replies.

eperez4

Mechanical
Jan 9, 2004
2
I have an excel file that contains x,y coordinate values. Is there anyway to generate a spline and define its nodes by importing a table from excel into solidworks?
 
Replies continue below

Recommended for you

Yes!

SW04

1) Start a new part
2) Insert\Curve\Curve through XYZ points (SW03 - Insert\Curve\Curve through free points)
3) Go to Excel and remove all headers - Just have the first callout for XYZ on the first row.
4) Save the file as a *.txt file.
5) There is a known bug in SW04. You have to open the file up in Notepad and re-save it as a *txt file. (Don't know what SP will fix this problem)
6) Click back to SW and click on the Browse button
7) Under files of type click on *.txt
8) Find the file and click open

It should auto populate if you have the sheet set up right. See the help on "Curve through XYZ points" It explains it there too.

Regards,

Scott Baugh, CSWP [borg2]
CSWP.jpg

faq731-376
 
......and it is in the Help if you look for it. BTW: The "bug" is related to saving the file as true plain ASCII text. Notepad always will do this correctly. Same reason it's best to open many system type data file with it.

I was - and he did. So at least I didn't get coal.....
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor