Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Sporning 3 party application from within NXCAM/MOM

Thread starter Jcamsystems
Start date Dec 20, 2006

Status: Not open for further replies.

Dec 20, 2006

Jcamsystems

Aerospace

Hello we’ve trying to better integrate our 3rd party post processing application into NXCAM. Does any body know how to fire up a 3d party application directly after the creation of a CLSF file as pass its location within the Temp directory as a parameter. I don’t think I can use the event MOM_end_of_program as the CLSF file hasn’t been closed. Does any one know how any other way to do it?