Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

spring dowel pin-bend test

Thread starter kkg123
Start date Dec 31, 2008

Status: Not open for further replies.

Dec 31, 2008

kkg123

Mechanical

dear friends

we have a bend test for spring dowel pin. it says that spring dowel pin when bend up to 90 deg along split side should not crack. but i could not locate any reference standard to this test.

hardness is 46-53 Rc and OD is .083-.089"(INCH)

can any one help to locate any reference standard to this test.

kkg