Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

spring simulation

Status
Not open for further replies.

klosar

Mechanical
Joined
May 27, 2006
Messages
13
Location
SI
hello. is it possible to simulate springs in catia?
for example, I'd like to draw 4 round springs that push sheet metal on the top. shet meetal would have limited movment only on horisontal direction. now when I draw shet metal in flat state, is it possible to make it bend automatically in assembly and be left like this or do I have to make a seperate simulation and draw it in bent state? also I'd like round springs to extend automatically.

thanks
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top