Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Sress relieving 25/4 Stanless castings
- Thread starter rinkman11
- Start date
EdStainless
Materials
Typically you would do it after rough machine and before final.
That way you would take care of stresses both from casting and rough machining.
It should give you better dimension control at final this way.
= = = = = = = = = = = = = = = = = = = =
Plymouth Tube
That way you would take care of stresses both from casting and rough machining.
It should give you better dimension control at final this way.
= = = = = = = = = = = = = = = = = = = =
Plymouth Tube
Agree with Ed, stress relieve after rough machining,there will be no movement of dimensions.
_____________________________________
"It's better to die standing than live your whole life on the knees" by Peter Mayle in his book A Good Year
_____________________________________
"It's better to die standing than live your whole life on the knees" by Peter Mayle in his book A Good Year
- Status
