Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ST10 Part Family Table

Status
Not open for further replies.

blitz97

Mechanical
Apr 25, 2007
79
Whenever we create a family of parts and add a table with the associated variables to a drawing, they are always listed as 3 place decimal tolerance. We cant determine how to change the tolerances of the variables listed in the table.

Has anyone had any dealings with this?
 
Replies continue below

Recommended for you

I figured it out.

for St10, just in case anyone needs to know, the "Base unit" tolerance for the "Length" measurement under the Units section for the drawing itself needs to be set at the tolerance you want. This can be found under the Solid Edge options.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor