Thanks everyone who responded to my previous post. I believe I have found a good method to use to program this traveling saw. I am using stage programing with jump statements to wait for each state to complete. The only hangup I have now is how to initalize the process. If I simply use a set command with say an on button then the initial stage that the set command goes to would be scanned and activated every time the program is scanned. I have noticed that some Plc's have an initial stage that can be used but my Keyence doesn't. Any thoughts would be appreciated.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Stage Programming
- Thread starter nvpaul
- Start date
JayAnthony
Electrical
Use the keyence Instruction DIFU - Differention Up (commonly known as rising edge one-shot.)
Jay in Dallas
Visit the Omron Forum at MrPLC.com
Jay in Dallas
Visit the Omron Forum at MrPLC.com
- Status
Similar threads
- Locked
- Question
- Locked
- Question