tnrocha
Materials
- Jul 8, 2010
- 7
Hi again.
I have another problem in hands with a simulation in Abaqus CAE about a stamping process of a square cup.
I think there is a solution to simulate this but I can not find because I'm beginner with this program.
It gives to me the following error: too many attempts made for this increment.
The version i used was 6.9.1
Thanks for the attention.
I have another problem in hands with a simulation in Abaqus CAE about a stamping process of a square cup.
I think there is a solution to simulate this but I can not find because I'm beginner with this program.
It gives to me the following error: too many attempts made for this increment.
The version i used was 6.9.1
Thanks for the attention.