Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Standar for semi-trailer load capacity calculation

Thread starter 3JC
Start date May 25, 2016

Status: Not open for further replies.

May 25, 2016

3JC

Mechanical

Dear collages,

Hello to everybody, this is the first post that I do in this section. I am a FEM analysit, and I have to develop the structural analysis of a semi-trailer. Which specification shall I have to use for the determination of load cases and the matnitud of that loads and/or impossed displacements?

Thank you very much for your attention.

Regards,

3JC