Every time i start a new drawing and insert Standard 3 Veiws I end up with 4.
Where i would like a ISO view it always comes in as Front.
So I end up with 2 front views, any help would be most appreciated.
When you open the drawing & the views are visible, make sure you do not click anywhere on the drawing sheet area. Only click the Green check mark in the Views dialogue box.
When you want to insert an Isometric, or any other view, make sure that the view you want is highlighted in the dialogue box.
from (the City of) Barrie, Ontario.
Everyone has a photographic memory. Some just don't have film.
No problem ... Hey, a donkey is better than a stubborn mule & far better than an ignorant @$$. At least you had the decency to respond. Some posters don't.
from (the City of) Barrie, Ontario.
Everyone has a photographic memory. Some just don't have film.