Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Standard for Washers for use on Exchanger Girth Flange Bolting.

Thread starter lot1
Start date Apr 11, 2009

Status: Not open for further replies.

Apr 11, 2009

lot1

Mechanical

Is anyone familiar with the appropriate ASME, ANSI or ASTM standard normally quoted for washers to be used with A320 B8M studs with A194 8M nuts on an exchanger girth flange. We don't normally use washers, but when we have with alloy steel, B7/L7's, studs/nuts, we've used ASTM F436M, but what about for use with stainless steel?