Start Command not working .Any Suggestion 1

[Aviatorbarath]

I have installed Catia VR20 in my PC. The command which i have used to invoke Measure item option, i have attached below.



That particular code works in my PC whereas in doesn't work in my Office with same version installed in my office. Can someone tell me wat am i missing to make it work.


Your suggestion will be very useful

Thanks
Barath

 

[ferdo]

What does it means "not working" ?

The command is launched but the OK button is not active because you don't have nothing to measure...at least is like this if you are performing this manually...

Regards
Fernando

https://picasaweb.google.com/102257836106335725208

https://picasaweb.google.com/103462806772634246699/

 

[Aviatorbarath]

Hi Ferdo

Not working in the sense. The same script gives error, which says "Unknown Commmand". In my original script, i have preselected the points to be measured...So selection is not an issue.. Problem is with the error

Actually in my actual scenario, i have to show "n" number of point coordinate for various points and take snapshot . Hence i am trying to use macro for that purpose

Thanks
Barath

 

[ferdo]

Hi

When you want to use StartCommand is good to check manually if is available in that workbench. For this go to menu View - Commands List and run it.

Also, to understand better your problem, it will be better to post your code and the sample part (no one want to loose time to recreate your scenario - by the way, the part, as it is in your picture, will work as I described, launch the command without OK button being active).

Regards
Fernando

https://picasaweb.google.com/102257836106335725208

https://picasaweb.google.com/103462806772634246699/

 

[itsmyjob]

from the module.1 -> right click export to .bas on your home computer
then create new catvba on office computer, import from .bas file

let us know if this work.

Eric N.
indocti discant et ament meminisse periti ​