Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Static Analisis

Thread starter Muninn
Start date Mar 5, 2007

Status: Not open for further replies.

Mar 5, 2007

Muninn

Mechanical

I have tried to see if i was able to make the program, make a analisis based only on the geometry of the product, i have done some basic analisis but using forces, and loads, im trying to see if is posible to get the critical points and areas of a product based only on geometry, any ideas?