static structural parameters

[stefathan]

Hello!!

I am very new in ANSYS. I have the following issue. I have 3 different parts one on top of the other. and I want to minimize the width of the one in the middle. When running the optimisation I want to put all 3 widths as an input and in each step of the continuous analysis the with that will be checked to be the same in all 3 of them. unfortunately it is not. ANSYS tries out random widths for each one in the 100 steps that I have defined.

Is there any way to set the value of my 3 parameters to be the same in all three of them???

Thanks a lot in advance!!!

Stef