Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Steam Mold Temperature Control Unit

Thread starter bonkers
Start date Jun 2, 2010

Status: Not open for further replies.

Jun 2, 2010

bonkers

Mechanical

I am requesting information for direct steam mold temperature control units for compression molding. I am converting from hot oil units. I need to know vendor sources and design tool info such as BTH/hr per lb. or sq. in. Max. temp. is 400 deg. F. Any tips and information on design, specifications and guidelines would be extremly helpfull!

Thanks,
Bonkers