Chav
Industrial
- Aug 5, 2001
- 1
I am looking at producing replacement automotive suspension components and am finding it hard to find advice on material grades..
If anybody can help with the selection process am am looking to produce the following components.
- Suspension wishbone fabricated from DOM tube.
- Spring platform to be formed by bending and welding of sheet
- Brackets to be produced by cutting, welding and bending of plate.
I know this does'nt give much to go on, I have just started this project and being based in Thailand I am finding it very hard to find advice.
Many thanks to any body who can help
Chav
If anybody can help with the selection process am am looking to produce the following components.
- Suspension wishbone fabricated from DOM tube.
- Spring platform to be formed by bending and welding of sheet
- Brackets to be produced by cutting, welding and bending of plate.
I know this does'nt give much to go on, I have just started this project and being based in Thailand I am finding it very hard to find advice.
Many thanks to any body who can help
Chav
