Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

steel type for clutch throw out

Status
Not open for further replies.
Mike450

Mike450

Materials
Mar 7, 2003
6
what is a suitable steel grade for the 'trumpet' section of a clutch throwout bearing. Looks like a short velocity stack and presses into the bearing and acts on the pressure plate fingers. It is for a 1954 MG racing clutch.
 
Status
Not open for further replies.

Similar threads

G
  • Question
Stainless Steel for ASME BPVC VIII
Replies
3
Views
3K
Andy Mayfield
A
Johnwoo1991
  • Question
F9 and F91 steel for low temp
Replies
1
Views
1K
EdStainless
EdStainless
FrancoisY
  • Question
Material 12L14 Steel
Replies
3
Views
2K
dtimberlake
D
OSU Engineer
  • Locked
  • Question
Making Clutch Race with Minimal Distortion
Replies
1
Views
95
TugboatEng
TugboatEng
R
  • Question
Test locations in Steel Casting.
Replies
1
Views
147
EdStainless
EdStainless

Part and Inventory Search

Sponsor

Back
Top Bottom