Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

STEM MATERIAL

Status
Not open for further replies.
Replies continue below

Recommended for you

Sort by date Sort by votes
Dear Dan,
AISI 4140 has a higher yield strenght value.
If you need to use a SS material you have to change from SS 316 to 17-4PH or F51.

Ciao
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

TiCl4
  • Locked
  • Question
Valve Seat/Stem Material for Monomer Service 1
Replies
7
Views
22
shvet
shvet
yamoffathoo
  • Locked
  • Question
How does a 8" Crane 465.5 Gate Valve Stem Separate ? (cast iron gate & manganese bronze ste
Replies
4
Views
28
yamoffathoo
yamoffathoo
skengg
  • Locked
  • Question
NON-ROTATING STEM TORQUE CALCULATION
Replies
0
Views
7
skengg
skengg
Material Engineer 98
  • Locked
  • Question
Stellite-6 requirement on Solid Inconel 825 Trim material
Replies
1
Views
21
Danlap
Danlap
skengg
  • Locked
  • Question
MATERIAL GRADE IDENTIFICATION. 2
Replies
3
Views
22
skengg
skengg
Back
Top