STL conversion problem

[SWscience]

When I export a part in eDrawing to stl format and try to open it in sw2004 sp4.1 , sw doesn't response ...
But I can open it in other cad systems.
Anyone has same experience ?

 

[SBaugh]

You cannot open or save an STL file in eDrawings04 or 05.

SW will open and STL file but it will not have any geometry, just triangular surfacing.

Regards,

Scott Baugh, CSWP
3DVision Technologies

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376
faq559-716 - SW Fora Users

 

[SWscience]

But when you open a part in eDrawing you can save as it in STL format if you allow stl conversion when you publish eDrawing of part.