jafarshah15
Civil/Environmental
Dear How to assign soil pressure on vertical retaining wall in ETABS 9.7.4 version. ? What element we have to assign to this Retaining wall ? WALL ELEMENT OR SHELL ELEMENT ?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Structural Modeling in ETABS 9.7.4
- Thread starter jafarshah15
- Start date
- Status
nabildhiyaulhaq
Civil/Environmental
you can idealizing the retaining wall as cantilever beam, it means you look it per meter or per foot
if the retaining wall is not symmetrical, you can assign it in ETABS too
you can also assign the soil pressure and water pressure as distributed load
if the retaining wall is not symmetrical, you can assign it in ETABS too
you can also assign the soil pressure and water pressure as distributed load
Enrique2015
Structural
A wall in ETABS is simply a vertical shell, you can simply divide the wall in horizontal strips and assign an incremental surface load to each strip. This is an approximation and slightly conservative but OK for all practical purposes. New versions of ETABS offer distributed area loads so this is easier to model with a single wall element.
- Status
Similar threads
- Question