Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Stub Acme 2G and 4G

Status
Not open for further replies.

Coog71

Industrial
Jul 26, 2012
1
I have a part where essentially we have two threads on the ID of one side of a part. The two threads are the same size and separated by a small thread relief. The only difference is, the Engineer wants to use a class 4G thread closest to the face and a class 2G thread after the first thread relief. Does anybody see this posing any issues during manufacturing or assembly? Can they be run during the same threading operation?
 
Replies continue below

Recommended for you

Coog

Yes it can machined at the same operation.
ref ANSI B1.5 latest rev.

It is the 3G & 4G tolerance of the pitch diameters, both are general purpose
sorry for the late reply

Mfgenggear
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor