Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Stud welding in ASME Sec VIII

Status
Not open for further replies.
BPVN

BPVN

Mechanical
Mar 27, 2008
39
Does ASME Sec VIII-Div 1, said about acceptance criteria for visual weld inspection of stud welds?
Any reference?
Thanks in advance.
BPVN
 
Replies continue below

Recommended for you

Sort by date Sort by votes
No criteria for visual inspection because a visual inspection is not going to be effective. I would conduct a rake test and see how many studs remain.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

victor6397
  • Locked
  • Question
Fatigue analysis for C95800 in ASME BPVC Sec VIII div.2
Replies
1
Views
469
TGS4
TGS4
jayinwww
  • Locked
  • Question
ASME Sec VIII Div 1 full pen weld on a mixer 1
Replies
4
Views
496
weldstan
weldstan
A
  • Question
ASME Section VIII Division 2 - Protecion Against Local Failure
Replies
6
Views
4K
antoniol
A
A
  • Question
5.4.2. Buckling analysis - Method A - ASME Section VIII Division 2 - negative EigenVaue
Replies
2
Views
2K
antoniol
A
M
  • Question
SCL Placement for Fillet Welds in ASME VIII Div. 2 DBA
Replies
10
Views
3K
Mecat24
M

Part and Inventory Search

Sponsor

Back
Top Bottom