Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Suitable Units Thermo-Mech Analysis

Thread starter Eser
Start date Oct 3, 2005

Status: Not open for further replies.

Oct 3, 2005

Eser

Mechanical

Hi all!

I have a question regarding the selection of suitable units for the calculation of a thermal-mechanical analysis. Inorder to have the stress in Mpa what should be the unit of:

-Specific Heat
-Conductivity
-Mass Density

If the units of force is N and the distances are in mm.

Thanks in advance,

Eser