Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Sulfatreat Bed Design

Status
Not open for further replies.
engpes

engpes

Mechanical
Joined
Feb 10, 2010
Messages
175
Location
US
What is the typical differential pressure to use in the design of a sulfatreat bed?

Standard operating pressure is at 50 psi, and we have always used 5 psid as the differential through the medium.

Is there any published value to use as a standard?

Thank you.
 
Status
Not open for further replies.

Similar threads

SD12
  • Question Question
General Flange Design.
Replies
8
Views
12K
SD12
SD12
LS_SMS
  • Question Question
Can Service Pressure Exceed Design Pressure?
2
Replies
21
Views
32K
r6155
r6155
ElCidCampeador
  • Question Question
Creep design - EN 13445
Replies
4
Views
7K
GD2
GD2
mechengineer
  • Question Question
Variant of reverse flange design
Replies
10
Views
5K
TGS4
TGS4
Trestala
  • Locked
  • Question Question
Catalyst Bed Support Beam Deflection
Replies
3
Views
574
Trestala
Trestala

Part and Inventory Search

Sponsor

Back
Top