Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Sump Pack or Pump Pack?

Status
Not open for further replies.

jartgo

Civil/Environmental
Oct 20, 2005
220
This past week I was speaking with an electrician and he was describing a control relay for pumping systems (I'm in the water/wastewater industry), which he was calling a "sump pack" or "pump pack."

What I understood him to be describing was a single control module that would replace multiple relays, as would normally be found in a small (less than 25HP) duplex pump station with lead/lag float controls.

I may not have fully understood what he was describing, as that is the purpose of this inquiry, to educate myself. I'm familiar with alternating relays and of course PLCs. What he was describing seemed like something in between. So, the question is, does anyone know what he might have been describing and where I could find more information, just for general knowledge.
Thanks in advance.
 
Replies continue below

Recommended for you

Try a Google search on "duplex pump controllers". There are a lot of options.

 
He may have been describing some variety of "Smart relay".
Google Siemens LOGO!

Bill
--------------------
"Why not the best?"
Jimmy Carter
 
Call THAT electrician up and ask him what he meant. Don't make us play "guess what an electrician meant". He really shouldn't have a problem defining what he was suggesting. I can think of a bunch of different things that could mean, so will others. The result can be you thinking the wrong thing and perhaps an ugly surprise down the road for you.

Keith Cress
kcress -
 
Thanks dpc, I believe a duplex pump controller is what he was referring to.

Waross, i had not seen the LOGO before, that's a neat little controller. I'll definitely keep that in mind for future small station projects.

Itsmoked, I'm sorry if you felt like I made you play, what I intended to solicit was a purely voluntary response. Too, I think if you re-read my initial post, you'll find that the question was phrased, "...does anyone KNOW..." if you interpreted that as a request for you to guess, you were mistaken. If you didn't know, a simple non-response would have been sufficient.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor