Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Supressing default drawing pilot hole callouts for tapped holes

Thread starter Tunalover
Start date Jul 1, 2014

Status: Not open for further replies.

Jul 1, 2014

Tunalover

Mechanical

Does anyone know how to do this in Creo? Your assistance would be much appreciated. In my opinion, the pilot hole geometry is something to be determined by the machinist depending on the application and is not required to be called out on the drawing!

Tunalover