Surface Deviation

[NM_Designs]

I have two bodies, that I am trying to show that the surfaces in body 1 are the same in body two. the surface deviation tool will only let me select a single face, rather than a set of tangent faces. Is there a tool in NX10 that will allow for this analysis to be performed.

Thanks

 

[jerry1423]

NX10 is a very old version (1994) so it is difficult to remember what tools were in there, but I hope somebody can help you.

Jerry J.
UGV5-NX1884

 

[cowski]

NX10 is a very old version (1994)...

FWIW, NX 10 was released in 2014.

The "model compare" tool will let you choose bodies in 2 different part files and will report which faces are identical and which are different. I'm not sure if it will work on 2 bodies in the same part, but might be worth a try.

www.nxjournaling.com

 

[jerry1423]

sorry, I was thinking UGV10

Jerry J.
UGV5-NX1884

 

[NM_Designs]

I will try the model compare feature. Thanks for the help.