Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Surface finishes for molded rubber parts...

Status
Not open for further replies.
quizzical1

quizzical1

Mechanical
Jul 6, 2004
180
Hi All,

Maybe a stupid question, but are there surface finish callouts for molded rubber parts? I know of the ARPM mold finishes F1 thru F4 but wasn't sure if that transferred to the molded part surface finish as well.

TIA,

Q~
 
Status
Not open for further replies.

Similar threads

tk90
  • Question
4140, Surface Hardness, and Coatings
Replies
12
Views
7K
mfgenggear
mfgenggear
FrancoisY
  • Question
Salt Spray Test - If Multiple Parts are being analyzed
Replies
5
Views
3K
mfgenggear
mfgenggear
mrmalcolm
  • Question
Half thickness tensile specimen retaining one rolled surface
Replies
2
Views
2K
mrmalcolm
mrmalcolm
Radius1
  • Question
Looking for specification for identifying pearlite in cast iron sample.
Replies
0
Views
520
Radius1
Radius1
S
  • Question
Software for Material Engineers
Replies
4
Views
3K
Saman2002
S

Part and Inventory Search

Sponsor

Back
Top Bottom