Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Surface Split in Design Modeller

Status
Not open for further replies.
BEMPE16524

BEMPE16524

Mechanical
Feb 17, 2008
362
hi,

How do i split 2 surfaces in Ansys12? I saw there is a Split Face command on the latest version.

R.Efendy
 
Status
Not open for further replies.

Similar threads

SothunN
  • Locked
  • Question
Surface traction
Replies
0
Views
67
SothunN
SothunN
md_salem
  • Locked
  • Question
how to do share topology in the design modeler in Ansys Workbench
Replies
1
Views
198
Stick.
Stick.
SothunN
  • Locked
  • Question
Traction force vectors on curved surface in Ansys Mechanical
Replies
0
Views
73
SothunN
SothunN
H
  • Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
1K
hmsilva
H
andradesilva
  • Locked
  • Question
how to select a cross-section for a line built in Design Modeler in ANSYS workbench 2023 R1
Replies
0
Views
103
andradesilva
andradesilva

Part and Inventory Search

Sponsor

Back
Top Bottom