Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
SURFACE TO SURFACE ERROR
- Thread starter RWAGZ
- Start date
When Cosmos sets up a general contact problem it defines contact surfaces based on element faces. Apparently there are more element faces in some portion of your model than Cosmos can deal with. Is there a lot of curvature in your model?
TOP
CSWP, BSSE
"Node news is good news."
TOP
CSWP, BSSE
"Node news is good news."
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question